Table of Contents
Advertisement
To select a Type
Put the digital surround processor into standby by pressing
Off (front panel or remote).
Hold down the A key on the front
panel until the display shows:
Hold down the A key for three
more seconds until the display shows:
It will then show the current Type
setting; for example:
Press
or
on the front panel to select the Type.
For example, if you have two analogue
speakers select the display:
Wait for a few seconds, while the
display shows:
Press the Off key on the front panel.
The display shows:
To set up the 568 for use with a 562
or 562V Multimedia Controller
Select 562 Mode as follows:
T y p e i n . . . 3
T y p e , w a i t . . .
T y p e 5 . 1 A A A
In 562 Mode all the digital and analogue sources use CD/D1 and
TV/A1 respectively:
Source
T y p e 2 . 0 A _ _
CD, Tape 2, CDR, Cable, DVD, and LD
Radio, LP, TV, Tape 1, VCR 1, and VCR 2
T y p i n g , w a i t
For information about connecting up the 568 see To connect to
a 562 or 562V Digital Control Unit, page 61.
E x i t i n g T y p e
Press the Source key on the front
panel; the display shows:
Press the Source key again to turn off 562 Mode. While 562
Mode is on the Dolby indicator is illuminated.
5 6 2 M o d e o n
Input
CD/D1
TV/A1
65
Advertisement
Table of Contents
