Before You Install...; Installation Requirements - Maytag Washer Installation Instructions Manual

Installation Requirements

Before You Install...

Consider
Location
Electrical Requirements
Water Supply Faucets
Water Pressure
Drain
Description
Use dimensions shown in manual to determine space needed for easy installation
and servicing.
Install washer on a solid floor. Never install washer on a platform or weak support
structure.
Wood floor constructions may sometimes need to be reinforced to minimize vibration
from unbalanced loads.
DO NOT install washer on carpeted floor. Carpet and soft tile surfaces also con-
tribute to vibration and/or tendency for washer to move slightly during spin cycle.
Washer requires 120 volt, 15 amp, 60 Hz power supply and 3-prong grounding
plug. Power cord is approximately 69" long. Refer to serial plate for specific require-
ments. Wiring diagram is located in control hood.
Water supply faucets must fit standard 3/4" (19.05 mm) female garden hose cou-
plings. Do not use slip-on or clamp-on connections.
NOTE: Water supply faucets should be easily accessible and turned off before
extended periods of non-use.
Static pressure measured at faucet must be 20–120 pounds per square inch (138 to
827 kPa). Water pressure under 20 pounds per square inch (138kPa) results in
extended washer fill time.
Drain receptacle must be able to handle hose with at least 1-1/4" (32 cm) outside
diameter. End of drain hose must be 36" (91.44 cm) above floor, or water may run
out of washer before end of cycle.
6