Computer Requirements; Connecting The Cables - Mark Levinson 53 Owner's Manual

Requirements

Connecting the Cables

14
The PC-compatible computer used to connect to the Nº53 must
Computer
have the following software installed:
• Windows
• Web browser (Microsoft
preferred)
Note
If DHCP is not active, then the computer must be set up with a static IP
address. Refer to the "Setting Up the Computer" section found later in
this manual for instructions.
The Nº53 can be connected to the computer in two ways – through
a router or directly to the computer. Before connecting the cables,
ensure that the computer and the Nº53 are powered off.
To Connect Using a Router:
1. Connect a network cable from the router to the Ethernet port
on the rear panel of the Nº53.
2. Attach a second network cable from the router to the Ethernet
port of the computer.
To Connect Without a Router:
Use a network crossover cable to connect the amplifier directly
to the computer. Different from a standard network cable, the
crossover cable is designed to connect network access ports directly
together without a hub, router, or switch.
Connect the crossover cable between the Ethernet port on the rear
panel of the Nº53 and the Ethernet port of the computer.
®
2000 or Windows XP
®
Internet Explorer
Router
o
N 53
Crossover
Cable
o
N 53
Mark Levinson
®
6.0 or higher
Computer
Computer