Managing Stations; Tv Stations - Loewe Operating Instructions Manual

Managing stations

TV stations

Various options for managing stations are available via the TV menu. For
example the description for TV stations. For radio stations the same applies,
except that the radio menu is called in radio mode (see also page 6).
➠ S tation management is not possible if a programmed timer recording
is still pending.
Search/update stations – Search wizard
In the search/update with the search wizard, new stations are searched
for which are not yet stored.
➠ You have to repeat the initial installation (see page 11)
and automatically search for new ones if you want to
delete all the existing stations and automatically search
for new ones. Do also use the first installation if you
want to change to receiving MHEG-5 stations (attend
restrictions for DVB software update, see page 5).
Call TV menu.
3 4 S elect Settings,
6 go to the menu line below.
3 4 S elect Stations,
6 go to the menu line below.
3 4 S elect Search wizard,
6 go to the menu line below.
In the upper info text the current search settings will now
be displayed:
Search wizard
Your TV carries out the update of the station range (search for new stations;
delete stations no longer broadcast) with the following settings:
Location of TV set
Signal source
TV menu
Settings
Stations
Search wizard
Change search settings
If you want to change these search settings:
3 4 S elect Change search settings,
OK wizard prompts search settings.
If you agree with these settings:
3 4 S elect Start search/update,
OK start search.
Red button: Abort current search/update.
- 4
United Kingdom
DVB-T
END
Start search/update
OK
Explanations of some search settings:
Set location Select the country for country-specific defaults and
station sorting.
Select antenna, cable, or satellite here, depending on
Signal source
where you want to search for new stations.
At this point you can also call a configuration of the
DVB-T and DVB-S antennae via the green button (see
page 1).
Antenna/cable: With selection of set location the conventional TV
TV/colour standard/colour standard is the default. This should only
standard be changed if stations with other standards are to be
searched.
Encrypted You can state whether coded stations are to be searched
stations for in the search/update. Select yes then coded stations
are also searched for. However, these stations can only
be received in connection with a CA module and the ap-
propriate Smart Card. Ask your dealer which Smart Card
you need to receive certain stations. Handling of the CA
module is described on page 4.
DVB-T If you want to run the station search independently of
the channel grid, select frequency search for the search
Search method
method.
DVB-C With the selection of set location the conventional set-
Settings tings will be preset. Only change this if you know other
symbol rates and modulation types or if you have to
specify the network ID for your cable network (informa-
tion available from your cable network provider).
If you want to run the station search independently of
the channel grid, select frequency search for the search
method.
DVB-S The symbol rate is specified by the satellite provider and
Symbol rate normally does not need to be changed.