Vesa Mount On Your Touchmonitor - Elo TouchSystems Entuitive 1925L Series User Manual

VESA Mount on Your Touchmonitor

Your touchmonitor conforms to the VESA Flat Panel Monitor Physical
Mounting Interface (FPMPMI™) Standard which defines a physical mounting
interface for flat panel monitors, and corresponding standards for flat panel
monitor mounting devices, such as wall and table arms. The VESA mounting
interface is located on the back of your touchmonitor and is shipped
pre-connected to the base.
Remove these four screws
(retain for reassembly)
Figure 2.4
N : The above drawing displays the VESA mounting interface after the removal of the
OTE
mounting cover and base.
N : You will need a screwdriver for the following steps.
OTE
• Remove the four screws in order to separate the stand from the monitor (see
Figure 1).
• Rotate the monitor 180° (ensuring the monitor will not be upside down when
mounted in the position shown).
• Reinstall the four screws.
• Route the cables through the cutout (if applicable) and mount the monitor to
the wall using the template in figure 2.
Stand and Display Separation
VESA mounting sufrace is located
8mm below the surface of the plastic.
2-13