25 mm (1”) treble driver. The midrange allow for the cable connectors. ers meet at ear height at the center of the and treble drivers are mounted in a Genelec Check that the amplifier unit is wired to the listening area. The loudspeakers should not Directivity Control Waveguide™...
Page 3
All OFF -4 dB ON -1 dB ON All OFF All OFF frequency response of the system will hard wall be adversely affected. Genelec In a corner -4 dB ON -6 dB ON -2 dB ON All OFF All OFF approved cloth grilles are available).
Page 4
Fig 1. Location of the acoustic axis in horizontal and vertical configurations. Note the alignment Fig 2. Amplifier unit connectors. of the DCW. Fig 3. Speaker mounting. Fig 5. Eliminating discontinuities. Fig 4. Speaker mounting details. Fig 6. Recess for loudspeaker connectors. (Rear view) Fig 7.
REMEMBER to disconnect the power supply This is to certify that Genelec HT324AC close proximity of the loudspeaker. by removal of the mains cable before chang- loudspeaker conforms to the following stand- ing a fuse.
Page 6
") Width 483 mm (19") Depth 250 mm (9 ")* www.genelec.com Genelec Document D0071R001 Copyright Genelec Oy 2.2006. All data subject to change without prior notice International enquiries: In the U.S. please contact: In China please contact: Genelec, Olvitie 5 Genelec, Inc., 7 Tech Circle...
Need help?
Do you have a question about the HT324AC and is the answer not in the manual?
Questions and answers