Source Setup - Halcro SSP100 Quick Setup Manual

2. Source setup

·
Select SSP100 SRC 1 for a HDMI source or SRC 3 for a component video input
·
Connect the DVD
i. HDMI output to the SSP100 HDMI input 1
Or
ii. Component video output to SSP100 Component input 1
·
Connect the DVD composite output to the SSP100
i. Composite input 1 for HDMI
Or
ii. Composite input 3 for Component
·
Connect the DVD Coax digital audio output to the SSP100 Coax 1 input for a DVD
with component video output. See setup settings below
HDMI
Source
SOURCE SETUP
Source
Title
>
Digital input
Preset
Analog monitor
Video type
Scaler bypass
EXIT
·
Press the remote Menu key or select EXIT to exit the menu and save the source
setup settings
·
Switch on the source (DVD player) and the video will be shown on the main display
output
Notes:
·
It is important to setup the DVD player to give the required audio and video outputs
·
The SSP100 front panel display will only show interlaced SDTV video (480i/576i)
·
To have video in the SSP100 front panel display at all times connect the source
composite output to the relevant composite input (rear panel 20)
MAIN MENU
Speaker setup
Audio setup
>
Source setup
Display setup
THX Audio setup
SOURCE SETUP
Trigger setup
1 Source
EXIT
DVD-1 Title
>
HDMI Digital input
No change Preset
Analog monitor
HDMI 1 Video type
Off Scaler bypass
EXIT
Component
Source
3
DVD-1
Coax 1
No change
Comp 1
Off