Elmo TSE270X Instruction Manual

Elmo TSE270X Instruction Manual

Ccd black and white video camera

Advertisement

Quick Links

T S E 2 7 0 X · T S E 2 7 1 X · T S E 2 7 2 X
I N S T R U C T I O N M A N U A L
The lightning flash with arrowhead symbol, within
an equilateral triangle, is intended to alert the user
to the presence of uninsulated "dangerous
voltage" within the product's enclosure that may
be of sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and maintenance
(servicing) instructions in the literature
accompanying the appliance.
CAUTION
Do not use any power supply other than specified.
W A R N I N G
T O R E D U C E T H E R I S K O F F I R E O R
E L E C T R I C S H O C K , D O N O T E X P O S E T H I S
A P P L I A N C E T O R A I N O R M O I S T U R E .
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK.
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The CAUTION label, shown on the left, is attached
on the top of camera.
INFORMATION
This equipment has been tested and found to comply
with the limits for Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are
desinged to provide reasonable protection against
harmful interference when the equipment is operated
in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the
instruction manual, may cause harmful interference
to radio communications. Operation of this equipment
in a residential area is likely to cause harmful
interference in which case the user will be required
to correct the interference at his own expense.
USER-INSTALLER CAUTION: Your authority to operate
this FCC verified equipment could be voided if
you make changes or modifications not expressly
approved by the party responsible for compliance
to Part of the FCC Rules.

Advertisement

Table of Contents
loading

Summary of Contents for Elmo TSE270X

  • Page 1 T S E 2 7 0 X · T S E 2 7 1 X · T S E 2 7 2 X I N S T R U C T I O N M A N U A L CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK.
  • Page 2: Important Safeguards

    IMPORTANT SAFEGUARDS 1. Read Instructions All the Safety and operating instructions should be read before the appliance is operated. 2. Retain Instructions The safety instructions and instruction manual should be retained for future reference. 3. Heed Warnings All warnings on the appliance and in the instruction manual should be adhered to.
  • Page 3: Specification

    Failure to do so may cause damage to the camera. * The socket-outlet should be installed near the equipment and should be easily accessible. SPECIFICATION TSE270X TSE271X DC12V (DC11V-16V) Approx.3.2W 15.734Hz 59.94Hz Internal 2P terminal 320 grm (0.71 lbs)
  • Page 4: Part Names And Functions

    INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU' AU FOND. Camera control switches Refer to "CAMERA CONTROLS." on page 6. MODEL TSE270X MODEL TSE271X MODEL TSE272X - 3 -...
  • Page 5: How To Connect

    Lens, coaxial cable for video signal and power supply are not supplied with a camera. 1. TSE270X: Turn on the unit by connecting the power cord of AC 24V power supply. TSE271X: Turn on the unit by connecting the power cord of DC 12V power supply.
  • Page 6 2.It takes about 10 seconds or more to obtain a stable synchronization after the power is turned on. This is necessary to stabilize the camera against the power noise. Video output Video input Video switcher Video output To AC 24V power supply (TSE270X) To AC 120V power supply (TSE272X) - 5 - Monitor TV...
  • Page 7: Camera Controls

    If a proper image cannot be obtained even after this adjustment, reset the potentiometer to its original position, and use the function control potentiometer signal of other camera. Caution: Before making adjustment, make sure that cameras have their power supplies connected with the same polarity. (not 180°apart) TSE270X, TSE272X SENS-UP LEVEL TSE271X SENS-UP...
  • Page 8 60 (2.36) ELMO CO., LTD. OVERSEAS SUBSIDIARY COMPANIES ELMO Mfg. Corp. ELMO Canada Mfg. Corp. 1478 Old Country Road, 44 West Drive, Brampton, Plainview, NY 11803-5034 Ontario, L6T 3T6, U.S.A. Canada Tel. 516-501-1400 Tel. 905-453-7880 Fax. 516-501-0429 Fax. 905-453-2391 E-mail:elmo@elmousa.com E-mail:info@elmocanada.com...

This manual is also suitable for:

Tse272xTse271x

Table of Contents