1
7
6
2
5
3
4
5
Setting the extent of the movement of the table plate 1:
In the transverse direction:
–
Slightly undo nut 8.
–
Set the extent of the movement in the transverse direction by
moving the crank along the slot.
–
Tighten nut 8.
In the longitudinal direction:
–
Undo screw 9.
–
Set the extent of the movement in the longitudinal direction by
moving the crank along the slot.
CAUTION:
Do not change the setting of the eccentric 10.
–
Tighten screw 9.
Replacing parts which have been removed
–
Remove the disc cam 6.
–
Replace the claw 7.
–
Replace the disc cam 6 and secure with screws 2 and nut 5.
–
Fit support 4 and secure with screws 3.
6
10
9
7
8
3
31