Epson LQ-1170 Service Manual page 80

3.2.5.10 Removing the Home-Position Sensor
1. Remove the printer mechanism from the lower case, as described in Section 3.2.4.
2. Remove the clips that secure the home-position sensor from the rear side of the base frame. Remove
the home-position sensor from the rear of the base frame.
3.2.5.11 Removing the Rear Paper-Out Detector
1. Remove the printer mechanism from the lower case, as described in Section 3.2.4.
2. Remove the two CBP(C) (M3 X 10) screws that hold the platen cover to the frame. Remove the platen
cover.
3. Remove the clips that hold the rear paper-out detector in the paper guide. Remove the rear paper-out
detector.
Figure 3-23. Removing the Home-Position Sensor
Figure 3-24. Removing the Rear Paper-Out Detector
3-17