Specifications; Hardware Specifications; Figure 1-2. Pin Configuration - Epson LQ-510 Technical Manual

REV.-A

1.2 SPECIFICATIONS

This section describes the specifications for the LQ-510 printer.

1.2.1 HARDWARE SPECIFICATIONS

Printing Method
Pin Configuration
Feeding Method
NOTE: Be aware of the following points regarding paper handling.
Friction Feed:
1. Do not use continuous paper.
2. Do not use a single sheet shorter than 7.28 inches (182 mm) or longer than 10.28 inches (257 mm).
3. Do not perform a reverse paper feed when the paper is within .34 inch (8.5 mm) from the top or within
.88 inch (22 mm) from the bottom.
4. Do not perform a reverse feed greater than 1/6 inch after the paper end has been detected.
5. Use the pull-out unit.
6. Do not use multi-part single-sheet forms.
Tractor Feed
1. Release the friction-feed mechanism.
2. Multiple copies must be joined by pasting at the perforation or tractor holes.
3. Paper for copies must be carbonless, multi-part paper.
LQ-510
Serial, impact, dot matrix
24 wires (12 x 2, staggered, 0.2 mm diameter)
Wires
(Column 1) Wires (Column 2)
I
I I
I I
I I
I .
- - - - - - -
I
- - - - -
I
I
I .

Figure 1-2. Pin Configuration

Friction feed, tractor feed (push tractor: standard; pull tractor: optional)
GENERAL DESCRIPTION
- -
1190"
1-3