Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes From Motor Unit Memory; 3-Button Remotes - Chamberlain Whisper Drive Security+ 459950 Owner's Manual

PROGRAMMING

NOTICE: If this Security ✚
in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
remote control to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
USING THE "LEARN" BUTTON
1. Press and release the "learn"
button on the motor unit. The
learn indicator light will glow
steadily for 30 seconds.
2. Within 30 seconds, press
and hold the button on the
hand-held remote* that you
wish to operate your garage
door.
3. Release the button when the
motor unit lights blink. It has
learned the code. If light bulbs
are not installed, two clicks will
be heard.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote,
fi rst erase all codes:
Press and hold the "learn" button
on motor unit until the learn LED
goes out (approximately 6 seconds).
All previous codes are now erased.
Reprogram each remote or keyless
entry you wish to use.
® garage door opener is operated with a non-rolling code remote control, the technical measure

To Add or Reprogram a Hand-Held Remote Control

USING THE DOOR CONTROL
1. Press the Prog <Learn> button
on the door control.
2. Press the Prog <Learn> button
again to confi rm Learn Mode.
3. Press the button on the
hand-held remote* that you
wish to operate your garage
door.
4. When the motor unit lights
blink, it has learned the code. If
light bulbs are not installed, two
clicks will be heard.
*3-Button Remotes (315 MHz)
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any
Security✚ ® 3-button
remote or mini-remote
can be programmed
to operate other
Security✚ ® garage
door openers.
38
® 315 MHz remote controls.