Periodic Maintenance; Daily/ Regular Maintenance - Century 400 CEXT7 Operating Instructions Manual

Table of Contents

Advertisement

PERIODIC MAINTENANCE

Twice a month, flush a white vinegar solution (One
quart vinegar to two gallons of water) or anti-
browning solution (mixed as directed) through the
extractor. This will prevent build-up of alkaline
residue in the system. If spray jets become clogged,
remove the spray tips, wash them thoroughly, and
blow-dry.
NOTE: Do not use pins, wire, etc. to clean nozzles
as this could destroy spray pattern.
Periodically inspect all hoses, electrical cables and
connections on your machine. Frayed or cracked
hoses should be repaired or replaced to eliminate
vacuum or solution pressure loss. If the cable
insulation is broken or frayed, repair or replace it
immediately. Don't take chances with electrical fire
or shock.
DAILY / REGULAR MAINTENANCE
Before making any adjustments or repairs to the
machine, disconnect the power cord from electrical
source.
1.
Empty unused cleaning solution from the
solution tank.
2.
Inspect and clean filter screen in solution tank.
3.
Flush pumping system with 4 or 7 liters of clean,
hot water.
4.
After each use, rinse tank with fresh water.
Periodically inspect the recovery tank and
decontaminate if necessary, using a Hospital
Grade Virucide or a 1-10 bleach to water
solution. Waste water should be disposed of
properly.
5.
Check for and remove any lint or debris around
vac shoe.
6.
Check spray jets for full spray pattern.
7.
Remove lint and dirt build-up from brush and
housing.
NOTE: Brush removal.
A. To remove brush, grab and pull brush out
B. To install brush, line up slots in brush core
8.
Check cooling air screen (located on frame
behind left wheel) for lint or debris.
9.
Check float and shut-off screen and clean as
necessary.
NOTE: Always store machine with brush in "Store"
position.
86037910 CEXT7 03/23/07
MAINTENANCE
from end opposite drive belt (operator's
right). Remove other end from brush driver.
with pin in driver on drive belt side
(operator's left) and push brush onto driver.
Then snap bearing end (opposite end) of
brush into retaining clip.
4-2

Advertisement

Table of Contents
loading

This manual is also suitable for:

10080360

Table of Contents