Cleaning Procedure - Century 400 CEXT7 Operating Instructions Manual

(30cm)
1in.
(25mm)
VACUUM
INTAKE COVER
1ft.
OFF
SOLUTION
INTAKE COVER
86037910 CEXT7 03/23/07

CLEANING PROCEDURE

Start at wall closest to power outlet. Pull
STEP
straight back without pushing down on
1
handle.
Release intermittent setting or turn off
STEP
continuous setting on brush/spray switch
2
approximately 1 foot before ending
cleaning pass.
Push down on handle to raise vacuum
STEP
shoe and brush before moving to the next
3
cleaning pass. Overlap brush contact
area approximately 1inch.
During operation, observe the following: The
STEP
extractor is equipped with clear internal covers
4
to facilitate operator viewing of dirty solution and
vacuum air flow.
During operation, observe the vacuum intake
cover. Large amounts of water or foam entering
the vacuum system can damage the vacuum
motor. If you notice either condition, shut down
the machine immediately. Empty recovery
tank and/or add defoamer to recovery tank.
3-8