DURKOPP ADLER 867 Service Instructions Manual page 65

2 1
6 5 4
Knife overlapping
When the knife 2 is in the bottom dead center, the overlapping should
amount to 0.5 mm.
–
Loosen screw 1.
–
Push the knife downwards until it overlaps the counter knife 3 for
0.5 mm.
–
Tighten the screw 1.
Position and pressure of the knife blades
The knife 2 should stand slightly inclined towards the counter knife 3.
The knife should cut safely with as little pressure as possible.
–
Loosen the screws 4 and 5.
–
Set the position of the knife carrier 6.
–
Tighten the screws 4 and 5 again.
Note:
The higher the knife pressure is set, the higher the knife wear will be.
2
2
3
GB
3
61