DURKOPP ADLER 867 Service Instructions Manual page 51

Correction
–
Loosen the screws (2x) on the control cam 4.
–
Swing out the thread-pulling knife 1 until the blade of thread-pulling
knife 1 comes flush with the blade of the counter-knife 2.
–
Bring the machine into the position "thread lever in its upper dead
center" (60°on the handwheel).
–
Shift the control cam 4 until its stops (against clamping ring 5) and
twist it on the shaft until the control cam 4 touches the roller 7.
–
Tighten the screws (2x) on the control cam 4 in this position.
GB
47