Table of Contents
Advertisement
3.
Connect the USB
cable to the camera.
The back lamp should
light red, indicating that
charging has started.
The back lamp will go out
when charging is
complete.
It takes about
190 minutes to bring a
fully dead battery to a full
charge.
• A battery that has not
been used for a long
time, or ambient
temperature extremes
can cause charging to
take longer than
normal. If charging
takes longer than
about six hours, a timer will terminate it automatically, even if the battery is not
fully charged. This is indicated by the back lamp flashing red. If the battery has
not been used for a very long time, charging may be terminated automatically
and the back lamp may start flashing red after only about 45 minutes. In either
case, disconnect the USB cable from the camera and then reconnect it to
resume charging.
• Note that even while the connector is fully inserted, you
still will be able to see the metal part of the connector as
shown in the illustration.
Back Lamp Operation
Lamp Status
Lit Red
Flashing Red
Off
Terminal cover
Making sure that the 6 mark on the camera is aligned
with the 4 mark of the USB cable connector, connect
the cable to the camera.
Description
Charging
Abnormal ambient temperature, USB-
AC adaptor problem, battery problem,
or charging terminated by timer (page
172)
Charging complete
18
USB-AC adaptor
USB cable
(included with camera)
[USB/AV] port
Small connector
Back lamp
Quick Start Basics
Advertisement
Table of Contents
