Replacing The Card Reader - Lenovo ThinkCentre M82 Hardware Maintenance Manual

What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 150.

Replacing the card reader

To replace the card reader, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 94.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 95.
4. Locate the card reader. See "Locating major FRUs and CRUs" on page 73.
5. Disconnect the card reader cable from the USB connector on the system board. See "Locating parts on
the system board" on page 75.
6. Press the blue retaining clip to remove the card reader out of the chassis.
Figure 33. Removing the card reader
7. Install the card reader retainer on the side of the new card reader.
Figure 34. Installing the card reader retainer
.
Chapter 9 Replacing FRUs (machine types: 2697, 2698, 2742, 2750, 2935, 2943, 2960, 2967, 2986, 2992, 2994, 2999, 3182,
3184, 3186, 3190, 3201, 3204, 3208, 3212, 3217, 3220, 3226, 3228, 3302, 3391, and 3392)
105