Connecting The Power Cable; Using The Remote Control; Connecting Other Equipment - Yamaha Disklavier Mark III series Operation Manual

Connecting the Power
Cable
Connect the Disklavier's power cable to an AC
wall outlet.
Important: Make sure that the voltage of the AC
wall outlet matches that marked on the
Disklavier's Serial No. plate.
Using the Remote
Control
The Disklavier is equipped with a remote control
which allows convenient control from almost
anywhere in the room. This chapter provides
notes on handling the remote control.
Installing Batteries in the Remote
Control
Before the remote control can be used, the two
batteries supplied with the Disklavier must be
installed.
Remove the battery cover from the rear of the
remote control, install the batteries, and then
replace the cover.
A diagram inside the battery compartment shows
which way the batteries should be installed. Make
sure you insert them correctly.
2
Battery Replacement
When the remote control fails to work from a
distance, replace the batteries.
• Replacement batteries should be UM-3, AA,
R6P, or LR6 type.
• Always replace both batteries.
• If the remote control is not to be used for a
prolonged period of time, remove the batteries
to prevent possible damage by battery leakage.
Important: Be sure to read the section on Handling
Batteries on page ii of "Important" for
details on the safe handling of dry
batteries.

Using the Remote Control

To use the remote control, point it at the remote
control sensor on the Control Unit.
Approx. 5 m (16 ft.)
30˚
30˚
Connecting Other
Equipment
☛ To connect audio instruments to the AUX
connectors, see Chapter 11 "Using the AUX
Connectors."
☛ To connect MIDI equipment, tone generator or a
synthesizer to the Disklavier, see Chapter 16 "The
Disklavier & MIDI."
☛ To connect a personal computer to the Disklavier,
see Chapter 17 "The Disklavier & Personal
Computers."
CO NT
RO L
UN IT
DK C5
5R CD
PL AY GENE RAL
/PA US
E
INSTRUME
ST OP NT
RE C
ST AN SO NG
DB Y SE LE
ON
CT /R
EV • FW
D
EN TE
R
PA RT
L
R VO ICE
FU N