Chapter 2 Names Of Parts And Their Functions; Control Unit - Front Panel - Yamaha Disklavier Mark III series Operation Manual

Chapter 2
Names of Parts and Their
Functions
This chapter describes the functions of the buttons and other parts of the Disklavier.
Control Unit — Front Panel
1 2 3
PLAY/PAUSE
STOP
STANDBY
ON
6 7
1
[STANDBY / ON] button
Turns on the Disklavier or puts it in Standby
mode. Press once to turn it on, and once again to
put it in Standby mode.
Note: In Standby mode, the Control Unit is in effect
turned off. However, electrically it is in a state
in which a very small quantity of power is
being consumed, as the MAINS switch is still
on and the Disklavier is still connected to the
AC power receptacle.
2
Remote control sensor
When using the remote control, point it toward
this sensor.
3
Display (LCD)
Shows various information.
4
Floppy disk drive
Insert a floppy disk such as a PianoSoft or
PianoSoft . Plus song disk here.
4
CONTROL UNIT DKC55
GENERAL
INSTRUMENT
DRIVE SONG SELECT/REV • FWD
PART
L
R
8 9 0 q w er
4
VOLUME
ENTER
TEMPO
TRANSPOSE
METRO-
REPEAT FUNC. BALANCE
NOME
t y
5
Floppy disk eject button
Used to eject the disk from the floppy disk drive.
6
[PLAY/PAUSE] button
Used to start and pause playback.
7
[STOP] button
Used to stop playback.
8
[DRIVE] button
Used to select a disk. Toggles the floppy disk and
Memory Disks (0 ~ 9 and A ~ F).
9
[SONG SELECT/REV
In Stop mode: Used to select songs.
In Play mode: Used to fast preview and review.
In Pause mode: Used to fast forward and reverse.
0
PART [L] [R] buttons
For L/R and Ensemble songs, these buttons allow
you to choose which part to play back: L (left-
hand) part, R (right-hand) part, or both.
Press both buttons together to turn pedal playback
on or off so that you can play the pedals yourself.
5
–10 –8 –6 –4 –2 0
• • •
–/NO +/YES
u i
FWD] buttons
•