Vauxhall Meriva Owner's Manual page 142

Pict ure no: 17890s.t if
Fault
If a fa ult occ urs in the Easytronic, control
indicator A illuminates. In the event of
serious faults, "F" a lso app ears in the
transm ission display .
It is possible to continue driving if only
control indica tor A illuminates. Ma nual
mode can then no longer be selected.
If "F" also ap pears in the transmission
display, it is not possib le to continue
driving.
Hav e the cause of the fault elim inated by a
workshop. The self-diag nosis integrated
into the system allow s rap id fault
identification.
Picture no: 14721s.tif
Interruption of p ower supply
The clutch is not d iseng aged if the vehicle
battery is discha rg ed and a gear has been
selected. The vehicle cannot move.
If the ba ttery is flat, start the v ehicle using
jump lead s – see page 172.
If the cause of the power failure is not a
discharged battery , conta ct a workshop. If
the vehicle m ust be rem ov ed from flowing
tra ffic, relea se the c lutch as follows:
1. Apply handbrak e and switch off ignition.
2. O pen bonnet and engag e support.
Driving an d Operation
3. Clean Easytronic around the cap (see
illustration in prev ious c olumn) so that no
dirt can get into the opening w hen the
cap is rem oved.
4. Rotate ca p to sla cken a nd remove by
lifting upwa rd s – see illustration in
previous column.
5. Turn the adjusting screw clock wise using
a flat-head screwdriver (vehicle tools 3 –
see page 176) until clear resistanc e can
be felt. The clutch has now been
disengaged.
Do not turn bey ond the resistance, since
this can d amage the Easytronic.
6. Fit cleaned cap ag ain. The cap must be
in full contact w ith the housing.
Towing the vehic le and starting the eng ine
is not perm itted when the clutch has been
released in this way , although the vehicle
can b e m ov ed a short distance.
C ontact a workshop immediately.
137