Rear Panel - Tascam US-1641 Owner's Manual

IMPORTANT SAFETY INSTRUCTIONS

Rear Panel

USB connector Use a USB cable to connect this to
0
the host computer. (Please note that this connector supports
only USB 2.0 connection.)
DIGITAL IN jack This is an RCA connector that
A
inputs a stereo S/PDIF digital signal.
DIGITAL OUT jack This is an RCA connector that
B
outputs a stereo digital signal. Signals output from the
LINE OUT [1/2] or [3/4] jacks can be output digitally from
this jack (as set in the Control Panel). You can also select
S/PDIF or AES/EBU as the digital signal format in the
Control Panel.
MIDI OUT connector Transmits MIDI messages
C
received from the computer.
MIDI IN connector Receives MIDI messages.
D
The received MIDI messages will be transmitted to the
computer.
2 – Features of the US-1641
INPUTS [11-14] jacks and LEVEL switches These
E
are TRS 1/4" phone, balanced line input jacks. Use the
LEVEL switches to set the nominal level to –10dBV or
+4dBu.
NOTE
You cannot adjust the gain level for these inputs.
LINE OUT [1-4] jacks These are stereo TRS 1/4"
F
phone, balanced line output jacks (sleeve = ground, tip =
hot, ring = cold). The nominal output level is +4dBu. These
jacks output signals received from the computer. Use DAW
software to switch between LINE OUT [1/2] and LINE
OUT [3/4] .
MONITOR OUTPUTS [L/R] jacks These are stereo
G
TRS 1/4" phone, balanced output jacks (sleeve = ground,
tip = hot, ring = cold). These jacks enable you to monitor
monaural mix input (1-14) signals and/or output signals
received from the computer. Use the MONITOR knob on
the front panel to adjust the output level.
AC IN connector Connect the supplied power cable
H
to this connector and an AC outlet.
 
TASCAM US-1641 TASCAM US-1641