Autolocation Controls - Tascam DA-88 Owner's Manual

Autolocation Controls
0 Setting Locating Points
Two locating points (MEMO I and MEMO 2) can be established en a given tape.
Q Repeat Play
To set MEMO points :
F'ress MEMO (1 or 2) at the desired point during Play, or during Stop if the tape is
at the point you want to specify as a locating point
To check MEMO points :
Press the
DISPLAY
switch (when the tape stops or is running) until the MEMO 1
(or 2) LED lights. The display is now showing the locakm stored into the
correspwding register.
To fine Wne MEMO points :
When the MEMO point ycm want to fine tune is showing in the display, press A
m increment the numbers shown, or press V to decrement them.
TCJ speed up the tuning, you czin hold down either A IX V and press
DISPLAY.
Each time YOU press DISPLAY,
the next upper (left) two digits will fast
increment
To clear MEMO points :
Hold either A or V and press the other. The locating point currently shown in the
display is erased from memory, as confirmed by "OO:OOzOOz~ appearing instead.
To aumloca&
the tape to MEMO points :
Press LOC 1 m locate the tape m the MEMO I point. Press LOC 2 to locak the
tape m the M!ZMO 2 point
At the end of locating funckms the tape will stop unless AUTO PLAY is
previously pressed.
Pressing
REPEAT
lets the tape play between MEMO I and MEMO 2 points over
and over.
The MEMO I point should not be lower than the MEMO 2 point. The DA-88
understands the lower MEMO point as the start point of loop, and the higher
point, as the end.
NOTE
There
muat be 4 least
5
seconds between the two MEMO poink
To interrupt momen&wily repeat play, press
STOP. Press PLAY to re~umc play.
To exit repeat mode, prw REPEAT.
o
If only either MEMO I or MEMO 2 point is established, the tape will repeat
between that MEMO point and the counter zero poinL
22