Tascam DA-88 Owner's Manual page 14

0 Manual punch in and out
18
Punch-in Rehearsal
13. Praaice
the pafonnance until you are sure that you will get it right when
acmally recording. Remember, once you punch-in over existing material, that
original signal is erased !
AcWal, Auto Punch In and Out
Once you're sure yew performance and the in/out points selected are correct, you're
ready to acwally punch into record. The RIISL LED should be on solid. All
tracks should be in SAFE mode except the one you intend to record.
14. Press AUTO IN/OUT. Its LED will aart blinking.
15. Press PLAY.
The tape will punch inm record, and punch out of record, as progratne& and
after 3 seconds of postroll, the m.pe will rewind, stopping at the preroll start
point, all as you have anticipawd during Rehearsal.
16. Press PLAY to check if the new recording sounds right.
To exit Auto In/Out mode :
Press CLEAR. The AUTO IN/OUT LED will turn off, and the RHSL LED as
well.
To accommodate various situations the DA-88 allows you m let the tape manually
punch into and out of record, too.
There are three ways m punch into record mode.
RECORD-Wiggered punch-in
1.
2.
3.
4
Locate the mpe to a point a few seconds lower than the expected punch-in
point.
Put the punch-in track into Ready mode by pressing its REC FUNCTION
switch.
Press INSERT m Ia its LED turn on.
Press PLAY to let the tape start playing.