Tascam DA-88 Owner's Manual page 11

.
1
I
O u t p u t M o d e S e l e c t i
5.
Check to see that VARI
S P E E D
is NOT activated. If its LED is on, turn it off
by pressing the switch.
6. Select the track or tracks to record on by pressing their REC
F U N
switch.
7. If you intend to record analog audio, let the soon% start playing, and adjust its
o u t p u t l e v e l c o n w o k
until the DA-Ws meter peaks at the reference level of
"0". If the OVER indicator lights, it shows distortion occurred.
If you intend to record digital audio, no level adjustment is required.
8. Hold
R E C O R D
and press
P L A Y
to let recording start.
9. When recording is complete, press
S T O P .
IO. To prevent recording from accidentally erasing, put the track(s) into Safe mode
by pressing their
R E C F U N C T I O N
switch again.
Playback
11. Check to see that the audio ootputs are correctly connected to your monitor
system, through a mixer or not.
12. Rewind the tape to the beginning of the recording you want to let play, then
press
P L A Y .
13. To stop play (detinitely or momentarily), press
S T O P .
To use the digital outputs, hold down A and press
D I G I T A L I N
when the display is switched to ABS. "Digital"
will appear momentarily on the display, showing the digital output mode is selected. Each time you press
D I G I T A L I N
while holding down A, the output mode toggles "Digital" and "Analog." Revert to the analog output
mode when you use tie analog outputs.
15