Setting Up Your Phone - Sanyo S1 Sprint User Manual

Setting Up Your Phone

1.
Install the battery (if necessary).
Slide the battery release latch and then slide the
battery cover and remove it from the back of the
phone.
Insert the battery into the opening, making sure the
connectors align. Gently press down to secure the
battery.
Replace the battery cover and slide it until you hear a
click. Then, slide the battery release latch.
(See "Installing the Battery"on page 23 for the
illustration.)
2.
Press and hold
Your phone will turn on, search for Sprint service,
and enter standby mode.
If your phone is not yet activated, or if it is locked, see
"Getting Started With Sprint Service"on the
following page for more information.
3.
Make your first call.
Use your keypad to enter a phone number.
Press
Note: Your phone's battery should have enough charge to turn on,
find a signal, set up your voicemail, and make a call. You
should fully charge your battery as soon as possible. See
"Charging the Battery"on page 24 for details.
to turn the phone on.
.
Section 1A: Setting Up Service 3