Table of Contents
Advertisement
14
13
16
8
–
Tilt the machine head backwards.
–
Loosen screw 14.
–
Using the mounting aid 13, push the pre-assembled sewing foot
lifting solenoid upwards in a way that the push rod 15 gets engaged
in the upper guide bore hole.
–
Fasten the mounting aid 13 with the screw 14.
–
Unscrew the threaded pin 17.
–
Push all the cables to the left of the shaft 16 of the threaded pin 17
and fasten the threaded pin again.
–
Lead the cable of the sewing foot lifting solenoid to the rear side of
the machine through the drilled hole 18.
6
–
Tilt the sewing machine head to the front.
–
Screw the holder 10 to the housing using one of the screws 6.
–
Unscrew the screw 6a and screw it into the second mounting hole
of the holder.
–
Loosen the screw 14, remove the mounting aid and fasten the
screw 14 again.
–
Put in the spring 4.
18 17
16
6a
4
15
Hide quick links:
Advertisement
Table of Contents
