Programming The Positions - Duerkopp Adler 195 Service Manual

2.20.1

Programming the Positions:

1. Hold key P pressed.
2. Turn on the main switch.
3. For entry to the " Technician
Level 1" enter Efka Code-No. 1907
with the keys 1 ...0.
4. Press key E.
5. Enter parameter-no. F170
with the keys 1 ...0.
Press key E.
Press key F.
6. Turn the handwheel one full rotation in the machine direction and arrest in
position A with the enclosed timing pin.
Press key P twice.
7. Press key P.
8. Press key E twice.
9. Press key F.
Using keys + or - set
increment number 50.
10. Press key E.
Using keys + or - set
increment number 190.
11. Press key E.
Using keys + or - set
increment number 100.
12. Press key E.
Using keys + or - set
increment number 240.
13. Press key P twice.
14. Attention!
It is essential that a seam be sewn with thread trimming and raising the
pressure foot. This is the only way for a setting to be definately stored in the
memory. Without sewing the setting is lost when the machine is next turned off.
46
Code-No. C 0000 appears in the display.
Parameter-No. F100 appears in the display.
Service-Routine 1 (Sr1) appears.
Position 0 appears.
F170 appears in the display.
Service -Routine 2 (Sr2) and F171
appear in the display.
Position 1 and the set increment number
appear in the display.
Position 2 and the set increment number
appear in the display.
Position 1A and the set increment number
appear in the display.
Position 2A and the set increment number
appear in the display.
This completes the setting.