Wiring Diagram; Replacing Fuse - Dual AXXERA XDMA7200 Installation & Owner's Manual

RCA Preamp Output
Connections
SUBWOOFER
REAR
FRONT
Steering Wheel Interface Input
3.5mm
BLUE
BLACK
RED
YELLOW
Right Front
Gray/Black (-)
Gray (+)
Left Front
White/Black (-)
White (+)
XDMA7200
PAC SWI-PS connection
(sold separately)
Bluetooth Microphone Input
Connect the included
Bluetooth microphone.
Remote Turn-On
Connect to amplifier or power
antenna. Insulate wire if not used.
Ground
Connect to the vehicle
chassis ground.
Accessory
Connect to an existing ignition
circuit or switched 12 volt source.
Memory
Connect to the battery
circuit or constant 12 volt source.
Right Rear
Violet/Black (-)
Violet (+)
Left Rear
Green/Black (-)
Green (+)
3

Wiring Diagram

Antenna Input
Connect the vehicle antenna
Bluetooth Microphone
(must be connected for Bluetooth functionality)
FUSE
When replacing the fuse,
make sure new fuse is the
correct type and amperage.
Using an incorrect fuse could
damage the radio.
The XDMA7200 uses one
10 amp ATM fuse located
beside the wiring connector.