Intel Amt Setup And Configuration - Lenovo ThinkCentre M58p Manual

Power Loss, Intel ME will be powered on after returning from a G3 state. For Intel
ME to be active in the S5 state, the system needs to be powered on (S0) briefly,
then turned off (S5).

Intel AMT setup and configuration

Enter Intel AMT Configuration
The Intel AMT Configuration allows you to configure an Intel AMT capable
system to support the Intel AMT management features.
Select Intel AMT Configuration from MEBx menu, the Intel AMT Configuration
menu will be shown:
Host Name
Select Host Name, you will be prompted to set up your Intel AMT name.
Note: The host name here must not be the name of the operating system machine
name. However, if DHCP is enabled, the host name must be the same with
the operating system machine name.
TCP/IP
Select TCP/IP, you will see the following TCP/IP configuration menu of Intel
AMT. It allows you to change the TCP/IP configuration.
There are two options of DHCP:
DHCP = Enabled
TCP/IP settings will be configured by a DHCP server
DHCP = Disabled
It is required to set up the static TCP/IP settings for Intel AMT. If the system is in
static mode, a second IP address is required. This IP address is often called the ME
IP address and is different from the host IP address.
v IP address: Internet address of the Intel ME.
v Subnet mask: The subnet mask is used to determine which subnet IP address
the IP address belongs to.
v Default Gateway address: The default gateway of the Intel ME.
v Preferred DNS address: Preferred Domain name server address.
Chapter 5. Intel AMT setup and configuration based on Lenovo ThinkCentre M58p
13