Preparing A Good Foundation - Cal Spas LTR20111000 Owner's Manual

4

Preparing a Good Foundation

Your spa needs a solid and level foundation. The
area that it sits on must be able to support the weight
of the spa, with water and the occupants who use it.
If the foundation is inadequate, it may shift or settle
after the spa is in place, causing stress that could
damage your spa shell and finish.
Damage caused by inadequate or improper
foundation support is not covered by the
warranty. It is the responsibility of the spa
owner to provide a proper foundation for
the spa.
Place the spa on an elevated 3" - 4" concrete slab.
Pavers, gravel, brick, sand, timbers or dirt foundations
are not adequate to support the spa.
We strongly recommend that a qualified, licensed
contractor prepare the foundation for your spa.
www.calspas.com
If you are installing the spa indoors, pay close
attention to the flooring beneath it. Choose flooring
that will not be damaged or stained.
If you are installing your spa on an elevated wood
deck or other structure, it is highly recommended
that you consult a structural engineer or contractor
to ensure the structure will support the weight of 150
pounds per square foot.
To properly identify the weight of your new spa when
full, remember water weighs 8.33 lbs. per gallon. For
example, an average 8' spa holds approximately 500
gallons of water. Using this formula, you will find that
the weight of the water alone is 4,165 lbs. Combined
with the dry weight of the spa you will note that this
spa will weigh approximately 5,000 lbs. when full of
water.
2011 Portable Spa
LTR20111000, Rev. D