Operating Your Spa; 5100Dv, 6200Dv, And 6300Dv Electronic Control - Cal Spas LTR20111000 Owner's Manual

12

Operating Your Spa

5100DV, 6200DV, and 6300DV Electronic Control Operation
These instructions will describe features and options that your particular spa may not be equipped with.
Used for single pump
Used for two and three pump
Initial Start up
When first powered up, your spa will perform a self-
diagnostic check and go into priming mode. When
the control panel displays PR, do the following:
1. Press the JETS 1 button to turn on the pump and
let it run for 10 seconds. The pump should be
running in low speed.
2. Press the JETS 1 buttons again and let the pump
run in high speed for 10 seconds.
3. Press the JETS 1 button again to turn off the
pump. The pump should be left in the off position
www.calspas.com
systems
systems
Used for single pump systems
for 10 to 15 seconds.
4. Repeat steps 1 through 3 until water is flowing
through all the jets and all air is removed from
the plumbing.
When the spa has finished priming, the heater will
be activated and the water temperature will be
maintained in standard mode. The spa will heat to
100°F (37.5°C) at start up until the set temperature
is changed as described below.
2011 Portable Spa
LTR20111000, Rev. D