Section Two: Mounting LED-10 Series Annunciators
LED-10 Series Annunciator Preparation
The LED-10 Series can be surface mounted in
a three-gang electrical box, Fire•Lite P/N SBB-3
or semi-flush mounted in a three-gang electrical
box, Fire•Lite P/N 10103 or equivalent, with a
minimum depth of 2 3/16". Select and remove
the appropriate knockout(s), pull the necessary
wires through the knockouts and mount the
three-gang box in or on the wall depending on
the type of installation desired. Be certain that
power is not applied to the wiring during the
installation procedure.
Note: To ensure static protection, all enclosures, including the LED-10 Series electrical
box, must be connected to earth ground! Never use the shield of the communications
wiring for static protection.
To mount the LED-10 Series Annunciator in the electrical box, the trim ring must first be
removed. The trim ring is held in place by two screws inserted through the top and
bottom edge as illustrated above. Removal of the trim ring will expose a metal flange
with mounting holes.
LED-10 Series Trim ring
(P/N 23165)
Figure 2-1: LED-10 Series Hardware
3-Gang Electrical Box P/N: 10103
(semi-flush mount)
Figure 2-2: LED-10 Series Backboxes
3-Gang Electrical Box P/N: SBB-3
Document 50400
Rev B
10/27/97
Screw
Screw
LED-10 Series flange
(surface mount)
P/N 50400:B
13