Switching Display Mode - Alpine CVA-1004 Owner's Manual

Other Useful Features

Switching Display Mode

After carrying out steps 1 to 3 of "To display the
SETUP screen" (page 29), perform the operation
shown below.
1
Press and hold FUNC for at least 2 seconds in
the AUX mode.
Each press changes the display modes as
follows:
→ MODE 1 → MODE 2 → MODE 3 → MODE 4
(WIDE) (ZOOM) (CINEMA) (NORMAL)
MODE1
In the Mode 1 (Wide), the monitor displays a
normal picture wider to fit in the wide-screen
monitor by evenly stretching out the picture
horizontally.
40
-EN
FUNC
MODE2
In the Mode 2 (Zoom), the monitor displays a
normal picture wider to fit in the wide-screen
monitor by unevenly stretching out. The center
portion of the picture is stretched out only slightly
in order to make the important center portion of
the picture look natural.
MODE3
In the Mode 3 (Cinema), the monitor displays a
normal picture by stretching out the picture
horizontally and vertically. This mode is good for
displaying a cinema type picture with the
proportion of 16 to 9.
MODE4
In the Mode 4 (Normal), the monitor displays
normal picture at the center of the screen with a
vertical black belt at each side.