Gs ! N (Specifying The Character Size) - Citizen CT-S2000 Command Reference Manual

GS ! n
[Function]
[Code]
[Range]
[Outline]
[Caution]
[Default]
[See Also]
Specifying the character size
<1D>H<21>H<n>
0≤n≤255, where:
1≤vertical magnification≤8, 1≤horizontal magnification≤8
Specifies the character size (Vertical and horizontal magnification).
Bit
Function
0
1 Vertical magnification
specification
2
3
4
5 Horizontal magnification
6 specification
7
Table 1 Horizontal Magnification
Hex. Decimal
00 0
10 16
20 32
30 48
40 64
50 80
60 96
70 112
• This command is valid for all characters (alphanumeric, kana, and kanji) except for
HRI characters.
• This command is ignored if either the vertical magnification or horizontal
magnification is out of the defined range.
• In STANDARD MODE, the vertical direction is defined as the paper feed direction,
and the horizontal direction is defined as the direction perpendicular to the paper
feed.
• Setting memory SW 3-7 to ON allows the horizontal and vertical relations to be
interchanged when 90°-right-turnning of character is specified.
• In PAGE MODE, the vertical direction means the top-bottom direction of each
character. The horizontal direction means the side-to-side direction of each character.
If characters of different vertical magnification are contained in a line, the baseline of
each character is lined up.
• Horizontal and vertical magnification can also be specified/canceled by ESC ! but the
setting of command last processed is valid.
n = 0
ESC !
Refer to Table 2, "Vertical Magnification".
Refer to Table 1, "Horizontal Magnification".
Table 2 Vertical Magnification
Magnification
1 x (Standard)
2 x (Double
width)
3 x
4 x
5 x
6 x
7 x
8 x
- 30 -
Value
Hex. Number
Hex. Decimal
00 0
01 1
02 2
03 3
04 4
05 5
06 6
07 7
Decimal Number
Magnification
1 x (Standard)
2 x (Double )
3 x
4 x
5 x
6 x
7 x
8 x