Switching The Function Of The Remote Sensor; Setup; Setup Operation - Alpine VPA-B211A Owner's Manual

• The optional expansion box (VPE-S431) is required to
connect an external rear monitor.
• REAR 1/REAR 2 can be set when "Setting the External
Rear Monitor Output" (page 9) is turned on.
• If the source of REAR 1/REAR 2 is set to NAVIGATION,
though the source name of the rear monitor is displayed as
DVD, the navigation screen is output.

Switching the function of the remote sensor

The remote sensor of the external monitor can be switched, as
you prefer.
1
Press 8 or 9 on the SETUP screen and
select REMOTE CONTROL SEL.
2
Press g or f and select a monitor using
the remote control.
The monitor which has a priority to the remote
control operation is changed.
FRONT: The remote control eye of this unit is
effective.
REAR-1: The remote sensor of the external rear
monitor connected to AUX OUT1 of the
optional expansion box (VPE-S431) is
effective, and the remote control can operate
only the source selected for this terminal.
REAR-2: The remote sensor of the external rear
monitor connected to AUX OUT2 of the
optional expansion box (VPE-S431) is
effective, and the remote control can operate
only the source selected for this terminal.
3
To finish the setting, press and hold MUTE
for at least 2 seconds.
• REAR-1/REAR-2 is adjustable when the external expansion
box (VPE-S431) is connected.
• If REAR-1 or REAR-2 is set, DVD operation is not possible
from the unit's supplied remote control.

Setup

8
g
9

Setup Operation

To display the SETUP mode screen:
To watch a video source, your vehicle must be parked
with the ignition key in the ACC or ON position. To do
this, follow the procedure below.
1. Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2. Keep pushing the foot brake and release the
parking brake once then engage it again.
3. When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission
lever in the Park position.
Now, the locking system for the SETUP operation has
been released. Engaging the parking brake can reactivate
the SETUP mode, as long as the car's ignition has not
been turned off. It is not necessary to repeat the above
procedure (1 through 3), of "To display the SETUP mode
screen."
Each time the ignition is turned OFF, perform the
procedure of "To display the SETUP mode screen."
The following steps 1 to 4 are common operations to each
"Setting item" of Setup. Refer to each section for details.
1
Press and hold MUTE for at least 2 seconds.
The SETUP screen is displayed.
2
Select the desired setting item by pressing
either 8 or 9.
f
MUTE
Continued
7
-EN