G9Wd Packaging & Shim Removal - Bunn MHG Service & Repair Manual

G9 WD - Packaging & Shim Removal
MUST BE COMPLETED BY AUTHORIZED SERVICE PERSONNEL.
Step 1 - Remove & discard tape holding funnel arm in place. (Figure 1)
Step 2 - Remove & discard two silicon tubes between funnel guide &
housing. (Figure 2)
Step 3 - Remove four screws in front housing panel. (Figure 3)
Step 4 - Remove & discard shim under transducer. (Figure 4)
Step 5 - Replace housing panel and secure four screws. (Figure 3)
Figure 1
Figure 3
WARNING
DO NOT PLUG IN !
SEE INSTRUCTIONS BELOW BEFORE USING !
Figure 2
Figure 4
5
41545 111711