The Ceramic Hob; Using The Hob; Automatic Warm Up; Using The Stop + Go Function - Electrolux U28003 EKT6045 Instruction Manual

THE CERAMIC HOB

Do not use the appliance if the ceramic
glass is damaged.
becomes visible, disconnect the appliance
immediately from the electricity supply and
contact your local Service Force Centre.

USING THE HOB

•
The hob must be switched on (
setting any cooking function or programme.
•
For single hotplates press the increase
decrease control to vary the heat setting.
The highest number represents the hottest
setting and the lowest number represents the
coolest setting. Choose a setting appropriate to
the quantity and type of food to be cooked.
•
To operate the dual and triple hotplates press the
increase or decrease control to vary the heat
setting and then press the hotplate icon to
activate the additional heat zones. When a zone
is activated a neon illuminates next to the
hotplate setting. To deactivate a zone press the
hotplate icon again.
•
To turn off a hob element press increase
and decrease controls together.

AUTOMATIC WARM UP

All cooking zones are equipped with an automatic
warm up function. The cooking zone switches to full
power for a certain amount of time and then
automatically switches back to the heat setting set.
Press and scroll through the heat settings to 9
then press again 'A' will show in the display. An
audible signal will sound. Now press
setting you require. The hob will show 'A' in the
display until the Automatic warm up programme has
finished then refers to the setting set.

USING THE STOP + GO FUNCTION

The stop + go function switches all cooking zones
that are switched on to the keep warm setting and
then back to the heat setting that was previously set.
This function can be used to briefly interrupt and then
continue the cooking process.
To switch on press
keep warm .
To switch off press
heat setting that was previously set.

USING THE HOB TIMER

All cooking zones can use each one of the two timer
functions at the same time.
If a cooking zone is switched off, the timer function
set is also switched off.
If a fault or crack
) before
to the
the hob display will show
the display will revert to the
or
Function
Automatic
cut-out
Countdown
timer
12
Condition Outcome after the
time has elapsed
acoustic signal 00
a heat setting is
set flashes
Cooking zone
switches off
acoustic signal 00
cooking zones
not in use flashes