Setting Telescopic Thread Stand; Changing Threads - White Superlock 834DW Instruction Book

3-2. Setting Telescopic Thread Stand
Extend the telescopic thread stand to its full height,
then turn it until the shaft clicks into its locked
position.
3-3. Changing Threads
The machine is supplied with thread but the follow
ing is an easy way to change them:
(1) Cut the thread in use near the cone spool
(behind the telescopic thread stand). Place the
new thread on the spindle and tie it to the end
of the original thread.
(2) Raise the presser foot lifter to lift up the presser
foot.
(3) Press down the tension release lever so that the
thread knot can pass through smoothly, draw
out the looper thread until the thread knot
comes to about 10 cm past the presser foot.
(4) When changing the needle thread, cut off
the thread knot before it reaches the eye of the
needle to avoid bending the needle as the knot
is pulled and caught in the needle's eye.
I
Cut thread Tie threads
3
—
—5—-