Canon LBP-800 Service Manual page 130

CHAPTER 3
B. Interface Controller PCB
1) Remove the 3 screws
Screws
Figure 3-7-2
2) Remove the 3 screws and pull the inter-
face controller unit to place it down.
Screws
Interface controller unit
Figure 3-7-3
3 - 20
3) Disconnect the 2 connectors and
remove the interface controller unit.
Connectors
Interface controller unit
Interface controller PCB
Figure 3-7-4
4) Remove the 4 screws and then the
interface controller PCB.
<< Note for reassembly >>
Make sure to install each of the two con-
nectors in the right positions when
installing the interface controller unit.