Table of Contents
Advertisement
The rear of the ADI-6432 provides the following connections: eight D-sub connectors (AES/EBU
I/O), two MADI optical, two MADI coaxial (BNC), two word clock (BNC), two MIDI (5-pin DIN),
one RS232 (D-Sub), and mains power.
MADI I/O optical: Standard MADI ports.
MADI I/O coaxial (BNC): Standard MADI ports.
AES I/O (25 pin D-sub): Each of the eight D-sub connectors provides four AES/EBU inputs and
outputs. The 25 pin D-sub connector is wired according to the widely spread Tascam standard
(pinout see chapter 14.7). The AES I/Os are transformer-coupled, high sensitivity type, there-
fore accept all common digital sources, even SPDIF.
WORD IN (BNC): A push switch allows to activate internal termination (75 Ohms).
WORD OUT (BNC): Standard word clock output.
MIDI I/O (5 pin DIN): MIDI input and output via 5-pin DIN jacks. Used for transmission of MIDI
data via MADI, and for remote control of the ADI-6432.
COM (9 pin D-sub): Serial interface for data transmission via MADI.
IEC receptacle for power connection. The specially developed, internal hi-performance switch
mode power supply makes the ADI-6432 operate in the range of 100V to 240V AC. It is short-
circuit-proof, has an integrated line filter, is fully regulated against voltage fluctuations, and sup-
presses mains interference.
8
User's Guide ADI-6432 © RME
Advertisement
Table of Contents
