Subscribe to Our Youtube Channel
Related Manuals for Outlaw LFM series
Summary of Contents for Outlaw LFM series
- Page 1 Variable Tuning LFM Series Low Frequency Modules LFM-1 EX and LFM-1 Plus Owner’s Manual Version 1.0...
-
Page 2: Please Read First
AC power source. Many modern electronics products feature automatic The high power output of your Outlaw LFM may require heavy power draw under full load turn-on circuits that may be activated during an installation, causing the potential for conditions. -
Page 3: Table Of Contents
■ If any of the above is missing from your shipment, please contact Outlaw Audio The contents of this manual are Copyright © 2007 by Outlaw Audio, LLC, and may not be immediately. duplicated or reproduced by any means, whether physical, electronic or otherwise without prior written consent from Outlaw Audio. -
Page 4: Before You Begin
X-OVER Switch plied with the LFM subwoofer on the floor surface in each corner of When an external crossover such as the Outlaw Audio ICBM is used, use this the location where the LFM will be placed. switch to bypass the LFM’s internal crossover. -
Page 5: Subwoofers, Bass And Overall System Performance
(in the case of systems with a subwoofer output) or ad- POWER INDICATOR Light ditional speaker wire. We recommend the Outlaw Audio PCA SUB cable, but any This indicator is green when the LFM is on and red when power is applied, high quality, shielded audio interconnect will work properly. - Page 6 FRONT RIGHT CENTER FRONT LEFT MASTER SWITCH CIRCUIT BREAKER 15 AMP OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT Riv Alifi WARNING: 120 VAC/60Hz HAZARDOUS ENERGY. MAKE PROPER SPEAKER 1800W CONNECTIONS: SEE OWNER'S MANUAL BEFORE USING. Right Sk Lft Sk Outlaw Audio...
-
Page 7: Connecting To A System With No Preamp Outputs
Owner’s Manual Setting the Variable Tuning LFM Series Subwoofer’s Controls Connecting to a System with No Preamp Outputs An easy way to find the right spot to place your new Variable Tuning LFM Series Subwoofer is to experiment with what we call the “Subwoofer Switch Trick.” This If no low-level subwoofer output is available, you will need to run speaker wires process puts the subwoofer where you normally sit and then lets you play the role from your main amplifier or receiver to the subwoofer amplifier. -
Page 8: Phase Switch
Y-adapter that is of equal or better quality than the subwoofer cables you Port Switch intend to use. (We recommend the Outlaw Audio PCA Y-Adapter.) Depending on your bass preference, your Variable Tuning LFM Series subwoofer To use the Y-adapter, insert the single male end of the cable to the subwoofer has two separate "tuning"... -
Page 9: Care And Maintenance
866-688-5292. rear panel of the subwoofer. This will prevent the automatic turn on circuits from It is important that only a service agent authorized by Outlaw Audio carry out any accidentally powering the system on during your absence. -
Page 10: Model Lfm-1 Ex Specifications
0 to 180 Degrees 118dB 115dB (subject to placement and room gain) (subject to placement and room gain) Dimensions (HxWxD) 21.5” x 17.0” x 24.0” Dimensions (HxWxD) 21.75” x 15.0” x 22.0” Weight Weight 80 lbs 58 lbs Outlaw Audio... -
Page 11: The Outlaw Audio 30-Day Satisfaction Guarantee
• Damage from failure to follow instructions contained in this Owner’s Manual In the event that you wish to return your Outlaw LFM back to us, for any • Damage from the performance of repairs by someone not authorized reason, please call to arrange for a Return Authorization Number. This will...
Need help?
Do you have a question about the LFM series and is the answer not in the manual?
Questions and answers