14. Using the vacuum pen 1 , remove the microprocessor from the system board
15. Position the microprocessor so that the notches 1 are aligned with the
136
Hardware Maintenance Manual
socket by lifting it straight up and out of the socket.
Important
Do not touch the gold contacts on the bottom of the microprocessor. If
you must touch the microprocessor, touch only the sides.
Note: The protective cover 3 is not used unless you are installing a new
microprocessor.
Attention:
Do not drop anything onto the microprocessor socket while it is exposed. The
socket pins must be kept as clean as possible.
corresponding tabs in the socket.