Replacing The Primary Hard Disk Drive - Lenovo ThinkCentre E50 Hardware Maintenance Manual

Replacing the primary hard disk drive

1. Remove the left-side and right-side covers. See "Removing the covers" on page
2. Disconnect the signal and power cables from the rear of the hard disk drive.
3. Remove the two screws that secure the drive on each side.
4. Slide the drive toward the rear of the chassis until it can be removed.
5. If the drive you are replacing has jumpers on the rear, make sure the jumpers
6. Slide the new drive into the bay until the screws holes on each side are aligned
7. Reconnect the signal and power cables to the rear of the hard disk drive.
8. Go to "Completing the FRU replacement" on page 116.
112
Hardware Maintenance Manual
85.
on the new drive are in the same exact position as on the drive being replaced.
and install two screws in each side of the drive.