Gathering - Brother 882-S85 Operation Manual

SEWING THE STITCHES
e
Iron the dart to one side so that it is flat.

Gathering

Use on waists of skirts, sleeves of shirts, etc.
a
Select a straight stitch and attach presser
foot "J".
b
Set the stitch length to 4.0 mm (approx.
3/16 inch) and the thread tension to
approximately 2.0 (weaker tension).
* If you press
stitch length will be set automatically to 4.0 mm
(approx. 3/16 inch) and the thread tension will be
automatically set to 2.0.
c
Pull the bobbin and upper threads out by
50 mm (approx. 1-15/16 inches) (see page
28).
a
b
a Upper thread
b Bobbin thread
c About 50 mm (approx. 1-15/16 inches)
68
after pressing
c
d
Sew two rows of straight stitches parallel to
the seam line, then trim excess thread
leaving 50 mm (approx. 1-15/16 inches).
a Seam line
b 10 to 15 mm (approx. 3/8 inch to 9/16 inch)
c About 50 mm (approx. 1-15/16 inches)
e
Pull the bobbin threads to obtain the
desired amount of gather, then tie the
threads.
f
Smooth the gathers by ironing them.
, the
g
Sew on the seam line and remove the
basting stitch.
a
b
c