Canon NP6320 Service Manual page 197

2. AE Adjustment
Make the following adjustments when the AE sensor or the DC controller PCB has been re-
placed.
1) Remove the VR cover at the back of the left cover.
2) Set the power switch ON.
• Wait until the wait period has ended.
3) Place an NB-3 or NA-2, NA-3 test sheet on the copyboard, and lower the copyboard cover.
4) Press switch SW300 on the DC controller PCB.
• 'C00' will appear on the Copy Count/Ratio indicator on the control panel.
• If 'C00' does not appear, press the "0" number key on the control panel so that 'C00' appears.
5) Press the Sort/Group key on the control panel.
• The scanner will move forward to the AE measuring position; then, the scanning lamp will go
ON. (Note)
6) Adjust VR301 on the DC controller so that "20" appears on the Copy Count/Ratio indicator.
7) Press the Sort/Group key.
• The scanning lamp will go OFF, and the scanner will return to the home position.
8) Remove the test sheet, place a sheet of newspaper on the copyboard, and lower the copyboard
cover.
9) Press the Sort/Group key.
• The copier will perform the same operations as described in step 5).
10) Make a note of the numerical value displayed on the Copy Count/Ratio indicator.
11) Press the Sort/Group key.
• 'C00' will appear on the Copy Count/Ratio indicator.
12) Press the "1" number key.
• 'C01' will appear on the Copy Count/Ratio indicator.
13) Enter the value recorded in step 10) using the numeric keypad.
COPYRIGHT © 1999 CANON INC.
For reference:
7.7
5
VR301
Test sheet Sheet of newspaper
Figure 10-225
7.7
5
Test sheet Sheet of newspaper
When the setting is lowered.
When the setting is raised.
Figure 10-226
CANON NP6320 REV.0 DEC. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 10 TROUBLESHOOTING
Document density
Document density
10-19