Cleaning And Lubricating The Drive Chain - Yamaha YZF-R1Z Owner's Manual

to chain slippage or breakage.
To prevent this from occurring,
keep the drive chain slack with-
in the specified limits.
TIP
Using the alignment marks on each
side of the swingarm, make sure that
both drive chain pullers are in the same
position for proper wheel alignment.
1 2 3 4
(a)
5
1. Axle nut
2. Drive chain puller
3. Drive chain slack adjusting bolt
4. Locknut
5. Alignment marks
3. Tighten the axle nut, then the lock-
nuts to their specified torques.
PERIODIC MAINTENANCE AND ADJUSTMENT
Tightening torques:
Axle nut:
150 Nm (15.0 m·kgf, 110 ft·lbf)
Locknut:
[ECA10571]
16 Nm (1.6 m·kgf, 11 ft·lbf)
(b)
Cleaning and lubricating the
drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
NOTICE
The drive chain must be lubricated
after washing the motorcycle, riding
in the rain or riding in wet areas.
1. Clean the drive chain with kero-
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive
7-27
sene and a small soft brush.
NOTICE: To prevent damaging
the O-rings, do not clean the
drive chain with steam cleaners,
high-pressure washers or inap-
propriate solvents.
[ECA11121]
chain with a special O-ring chain
lubricant. NOTICE: Do not use
engine oil or any other lubri-
cants for the drive chain, as they
EAU23025
ECA10583
7