Using Your Diverse Repeater - BT Diverse Repeater User Manual

Diverse Repeater ~ 4th Edition ~ 25th April '01 ~ 3831

Using your Diverse Repeater

The Repeater has the option to provide
a confidence signal (a confirmation
beep every 2 seconds) which sounds
when moving from the base station
area to the repeater area.
The default setting for the confidence
signal is OFF.
It is suggested that the confidence tone
is switched ON to aid installation and to
get an idea of the base and Repeater
reception areas.
Before starting this procedure the
Repeater's power adaptor must be
connected to the Repeater and the
mains socket, but switched OFF at the
mains socket.
At the Repeater:
•
Switch the power to the Repeater
ON for between 1 to 5 seconds then
switch it OFF.
•
Switch the power to the Repeater
ON again and wait for the LED on
the Repeater to slowly flash ON and
OFF (see note).
•
Switch the power to the Repeater
OFF then ON again (see note). If the
confidence tone was off it should
now be on and if the confidence tone
was on it should now be off.
14
If the LED did not flash on and off you will
have to repeat the above procedure again.
In steps 2 and 3 you must keep an eye
on the time when the power was turned on
while waiting for the LED to slowly flash
on and off. If you turn off the power after
it has been on for between 25 and
35 seconds you will reset the Repeater.
If this happens you will need to re-register
the Repeater to the base again.
Before re-installing the Repeater, it
needs to be reset. Before starting,
make sure the Repeater's power
adaptor is connected to the Repeater
and the mains socket, but switched off
at the mains.
At the Repeater:
•
Switch on for 1 to 5 seconds and
switch it off again.
•
Switch on for 25 to 35 seconds and
switch it off again. The Repeater
should now be reset.