BT Diverse Repeater User Manual page 12

Diverse Repeater ~ 4th Edition ~ 25th April '01 ~ 3831
Before attempting to register the
Repeater to the base station, make sure:
•
At least one handset is registered to
the base station.
•
Base station and handset are
powered up and in idle state.
•
Repeater power adaptor is connected
to the Repeater and the mains
socket – but switched OFF at the
wall socket.
•
Press the green
light on the front of the base station.
The registration light will now flash
on and off.
At the Repeater: (while base registration
light flashes)
•
Switch on the power to the Repeater.
The LED on the Repeater will come
on for 5 seconds and then flash on
and off (in bursts of 2 flashes). After
a short while the LED will stay on
for about 20 seconds, flash on and
off a few times then remain
permanently on.
The registration is now complete and
the unit is ready for use.
The Diverse 2-Line does not support call
hand-over from the 2-Line base station to
the repeater.
10
Before attempting to register the
Repeater to the base station, make sure:
•
At least one Diverse Executive
Handset or Deskphone is
registered.
•
Base station and handset/Deskphone
is powered up and in idle state.
•
Repeater power adaptor must be
connected to the Repeater and the
mains socket – but switched OFF.
Before the registration can take place
the base station has to be prepared for
button
Repeater operation. Follow the steps
opposite.
•
Press the
•
Press
•
Press
•
Press
SETTINGS.
•
Press
to enter the system code.
•
Enter the system code (default value
is 0000).
•
Press
•
Press
but DO NOT press
•
Enter the digits
•
Enter the digits
•
Press
The handset will return to the idle
screen.
•
Press the
•
Press
•
Press
button.
to highlight SERVICE.
.
to highlight SYSTEM
. You will now be prompted
.
to highlight INITIALISATION
at this point.
.
to confirm the entry.
button.
to highlight SERVICE.
.
.