BT Diverse Repeater User Manual page 11

Diverse Repeater ~ 4th Edition ~ 25th April '01 ~ 3831
Registration:
•
The Repeater power must be
turned off.
•
Press and hold the
the telephone base station until the
base station is in registration mode
(please refer to the user guide for
the telephone).
•
Connect the power to the Repeater
and switch on.
•
The green LED on the Repeater
will flash, after a short while the
LED will remain on permanently
indicating that the registration is
complete.
Before attempting to register the
Repeater to the base station, make sure:
•
At least one handset is registered to
the base station.
•
Base station and handset are
powered up and in idle state.
•
Repeater power adaptor is connected
to the Repeater and the mains
socket – but switched OFF at the
wall socket.
Press the following buttons:
For an Executive handset
button on
•
•
•
•
•
•
•
•
•
For a Classic handset
•
•
•
•
•
•
•
•
Registration:
•
•
•
•
Press the button.
Press the button.
Press the button.
Press the button.
Press the button.
Enter the 4-digit PIN code (default
is 0000)
Press the button.
Press the button.
Press the button.
Press the button.
Press the button.
Press the button.
Press the button.
Enter the 4-digit PIN code (default
is 0000)
Press the button.
Press the button.
Press the button.
The Repeater power must be
turned off.
Press and hold the
the telephone base station until the
base station is in registration mode
(please refer to the user guide of
the telephone).
Connect the power to the Repeater
and switch on.
The green LED on the Repeater
will flash, after a short while the
LED will remain on permanently
indicating that the registration is
complete.
button on
9